Term
Question 1
The Act of moving audio from several different sections of two or more tracks and and re-assembling them on a single track is normally referred to as_______ |
|
Definition
|
|
Term
Question 2
The act of moving audio with the multi-track by means of a secondary storage space is normally referred to as ________ |
|
Definition
|
|
Term
Question 3
The act of moving Audio within the multi-track is normally referred to as________ |
|
Definition
|
|
Term
Question 4
What is the approximate 1/16th note delay time for a song that is in 4/4 at 110 BPM? |
|
Definition
|
|
Term
Question 5
What is the approximate 1/8 note delay time for a song that is in 4/4 time at 95 BPM?> |
|
Definition
|
|
Term
Question 6
Which of the following statements best describes the difference between an audio subgroup and a fader(VCA) group? |
|
Definition
| D. does not change the signal flow |
|
|
Term
Question 7
The signal flow for re-amping is typically, starting with point of origin: |
|
Definition
| B. Multitrack, mic lines, mic panel, re-amp box, amp, mic, mic panel, console, MTR |
|
|
Term
Question 8
Which of the following patch points would NOT be a good place to return an outboard mic pre? |
|
Definition
|
|
Term
Question 9
Which is the better reason to take a D.I. form every possible instrument during a recording session? |
|
Definition
| D. re-amping and effect processing later |
|
|
Term
Question 10
which of the following choies is probably the way a mix engineer would make the bass track appear more pronounced precisely when the kick drum hits? |
|
Definition
| A. Gate the bass Track using kick as trigger |
|
|
Term
Question 11
On many consoles, a function known as channel output is available, typically used during a mixing session. What specific changes occur in the consoles signal flow when the channel output function is engaged? |
|
Definition
| C. Signal travels from the large fader to the small fader |
|
|
Term
Question 12
During a mix on the amek 9098i, the engineer asks you to to make patch that will allow the signal coming form track 17 to show up in the channel path of both module 17 and module 18. Which patch scenario below would most likely be the best choice? |
|
Definition
| d. off or from tape 17 to line amp in 18 |
|
|
Term
Question 13
Your client has rented a neve 1073 preamp and a Summit TLA-100 Compressor. These are to be used to record vocals directly to tape, completly bypassing the console. What patch would you make? |
|
Definition
| D. mic lines->Neve 1073 preamp-> TLA 100 comp->MTR send |
|
|
Term
Question 14
Buss 16 is dead. How can you route signal to track 16? |
|
Definition
| A. Patch from unused Buss to MTR send 16, assign the signal to that buss |
|
|
Term
Question 15
On the Amek 9098i, the preamp on I/O 44 is dead. However |
|
Definition
|
|
