Shared Flashcard Set

Details

G0A Electrical and RF Safety
G0A Electrical and RF Safety
12
Other
Not Applicable
02/26/2013

Additional Other Flashcards

 


 

Cards

Term
G0A01 -What is one way that RF energy can affect human body tissue? A. It heats body tissue B. It causes radiation poisoning C. It causes the blood count to reach a dangerously low level D. It cools body tissue
Definition
(A)
Term
G0A02 -Which of the following properties is important in estimating whether an RF signal exceeds the maximum permissible exposure (MPE)? A. Its duty cycle B. Its frequency C. Its power density D. All of these choices are correct
Definition
(D)
Term
G0A03 -How can you determine that your station complies with FCC RF exposure regulations? A. By calculation based on FCC OET Bulletin 65 B. By calculation based on computer modeling C. By measurement of field strength using calibrated equipment D. All of these choices are correct
Definition
(D)
Term
G0A04 -What does "time averaging" mean in reference to RF radiation exposure? A. The average time of day when the exposure occurs B. The average time it takes RF radiation to have any long-term effect on the body C. The total time of the exposure D. The total RF exposure averaged over a certain time
Definition
(D)
Term
G0A05 -What must you do if an evaluation of your station shows RF energy radiated from your station exceeds permissible limits? A. Take action to prevent human exposure to the excessive RF fields B. File an Environmental Impact Statement (EIS-97) with the FCC C. Secure written permission from your neighbors to operate above the controlled MPE limits D. All of these choices are correct
Definition
(A)
Term
G0A07 -What effect does transmitter duty cycle have when evaluating RF exposure? A. A lower transmitter duty cycle permits greater short-term exposure levels B. A higher transmitter duty cycle permits greater short-term exposure levels C. Low duty cycle transmitters are exempt from RF exposure evaluation requirements D. High duty cycle transmitters are exempt from RF exposure requirements
Definition
(A)
Term
G0A08 -Which of the following steps must an amateur operator take to ensure compliance with RF safety regulations when transmitter power exceeds levels specified in part 97.13? A. Post a copy of FCC Part 97 in the station B. Post a copy of OET Bulletin 65 in the station C. Perform a routine RF exposure evaluation D. All of these choices are correct
Definition
(C)
Term
G0A09 -What type of instrument can be used to accurately measure an RF field? A. A receiver with an S meter B. A calibrated field-strength meter with a calibrated antenna C. A betascope with a dummy antenna calibrated at 50 ohms D. An oscilloscope with a high-stability crystal marker generator
Definition
(B)
Term
G0A10 -What is one thing that can be done if evaluation shows that a neighbor might receive more than the allowable limit of RF exposure from the main lobe of a directional antenna? A. Change from horizontal polarization to vertical polarization B. Change from horizontal polarization to circular polarization C. Use an antenna with a higher front-to-back ratio D. Take precautions to ensure that the antenna cannot be pointed in their direction
Definition
(D)
Term
G0A11 -What precaution should you take if you install an indoor transmitting antenna? A. Locate the antenna close to your operating position to minimize feed-line radiation B. Position the antenna along the edge of a wall to reduce parasitic radiation C. Make sure that MPE limits are not exceeded in occupied areas D. No special precautions are necessary if SSB and CW are the only modes used
Definition
(C)
Term
G0A12 -What precaution should you take whenever you make adjustments or repairs to an antenna? A. Ensure that you and the antenna structure are grounded B. Turn off the transmitter and disconnect the feed line C. Wear a radiation badge D. All of these choices are correct
Definition
(B)
Term
G0A13 -What precaution should be taken when installing a ground-mounted antenna? A. It should not be installed higher than you can reach B. It should not be installed in a wet area C. It should limited to 10 feet in height D. It should be installed so no one can be exposed to RF radiation in excess of maximum permissible limits
Definition
(D)
Supporting users have an ad free experience!