Term
1. Ensure the switch does not participate in VTP but forwards VTP advertisements received on trunk ports. 2. Ensure all non-trunking interfaces (Fa0/1 to Fa0/24) transition immediately to the forwarding state of Spanning-Tree. 3. Ensure all FastEthernet interfaces are in a permanent non-trunking mode. 4. Place FastEthernet interfaces 0/12 through 0/24 in VLAN 20
|
|
Definition
switch#conf t switch(config)#vtp mode transparent switch(config)#interface range fa0/1 - 24 switch(config-if-range)#switchport mode access switch(config-if-range)#spanning-tree portfast switch(config)#interface range fa0/12 - 24 switch(config-if-range)#switchport access vlan 20 switch(config-if-range)#end switch# copy run start |
|
|
Term
VTP provides the following benefits: |
|
Definition
VLAN configuration consistency across the network Mapping scheme that allows a VLAN to be trunked over mixed media Accurate tracking and monitoring of VLANs Dynamic reporting of added VLANs across the network Plug-and-play configuration when adding new VLANs |
|
|
Term
DOT 1x config to set up the
radius server |
|
Definition
from console port on PC 1
Step1: Console to ASW1 from PC console 1 ASW1(config)#aaa new-model ASW1(config)#radius-server host 172.120.39.46 key rad123 ASW1(config)#aaa authentication dot1x default group radius ASW1(config)#dot1x system-auth-control ASW1(config)#inter fastEthernet 0/1 ASW1(config-if)#switchport mode access ASW1(config-if)#dot1x port-control auto ASW1(config-if)#exit ASW1#copy run start |
|
|
Term
Step2: Console to DSW1 from PC console 2 to configure
the distro to for the ACL
|
|
Definition
DSW1(config)#ip access-list standard 10 DSW1(config-ext-nacl)#permit 172.120.40.0 0.0.0.255 DSW1(config-ext-nacl)#exit DSW1(config)#vlan access-map PASS 10 |
|
|